Dura Cooler

Instructions for requesting a DuraCooler quotation:
1.	Complete the items shown in bold on the sizing sheet. This will enable Duramax Marine® to determine the correct DuraCooler® for your application.
2.	If the information shown in "non-bold" is available, it may permit Duramax Marine® to quote a less expensive DuraCooler®. Please provide as much of this information as possible.

GENERAL INFORMATION

Customer Contact Name
Phone Fax E-mail
Name of Vessel/Hull # New Construction: Yes or No
Type/Use of Vessel
Vessel Dimensions
Preferred Cooler: Single Pass    Double Pass

EXTERNAL CONDITIONS

Minimum Vessel Speed at Full Power knots
Maximum Ambient Sea Water Temp Fº
Location of Coolers: bottom side of hull.
Are there space restrictions on the hull? Yes or No
If yes, (size restrictions)

MAIN ENGINE INFORMATION

Manufacturer Model Number Quantity
Model Year of Engine HP @ RPM
Total Heat Rejection BTU/Min            Coolant Temp. to Engine
Pump Flow Rate or Range GPM                           to cooler
Exhaust Wet Dry          Aftercooler Circuit: Separate Combined
Method of attachment to hull: Flanged Nozzle Inlet/Outlet
Manufacturer of Gear (if gear to be cooled by DuraCooler®)
If Reintjes gear, provide water pump flow GPM
System pressure drop requirements:

GENERATOR

Manufacturer Model Number Quantity
Model Year of Engine HP: KW @RPM
Method of attachment to hull: Flanged Nozzle Inlet/outlet
System pressure drop requirements:
(will be sized for 0 knots unless otherwise directed.)

OTHER (Pump, thruster, etc.)

Manufacturer Model Number Quantity
Model Year of Engine HP: KW @RPM
Method of attachment to hull: Flanged Nozzle Inlet/outlet
System pressure drop requirements:
(will be sized for 0 knots unless otherwise directed.)